Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
Por um escritor misterioso
Descrição
Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from
Scalable extra prime - UltiMaker Cura - UltiMaker Community of 3D
Enable retraction options when lift head option is enable · Issue
Cura for Bambu X1 and P1 Series by AmaZz0r
Cura 2.7 strange retract behavior - UltiMaker Cura - UltiMaker
10 Good Reasons to Use Cura
slicing - Ultimaker Cura not always telling extruder to retract
too much retraction at beginning - Improve your 3D prints
Spiralize Outer Contour IGNORES all retraction · Issue #12498
Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
slicing - Ultimaker Cura is not always retracting in exported G
Travel settings
Retraction: Just say No to oozing
Cura makes supports start on second layer, is there any setting to
Retraction issue at layer change - UltiMaker Cura - UltiMaker
5 Best Plug-ins for Cura
de
por adulto (o preço varia de acordo com o tamanho do grupo)